More than ten years passed, and the metal mass had already transformed into a metal sword.

He Xiangyang still did not stop the forging hammer in his hand.

This was because, although the metal sword had taken shape, the law secret patterns within it had not yet reached their most perfect state.

At this moment, He Xiangyang still struck the metal sword hammer by hammer.

However, the force He Xiangyang was using now was very small.

But He Xiangyang's consumption, on the contrary, increased.

Because, when finely adjusting the secret patterns in the metal sword, to prevent the metal sword from deforming, He Xiangyang could not use too much force.

However, to conceptualize the secret patterns in the metal sword while using minimal force, He Xiangyang had to manipulate more laws.

Therefore, He Xiangyang's energy consumption increased instead.

Furthermore, in this step, He Xiangyang needed to constantly use his psychic energy to probe the situation inside the metal sword.

If it were an ordinary Sector Lord, or even an ordinary Undying, their energy might have been exhausted long ago.

However, this amount of energy was merely a drop in the bucket for the Life Ancient Tree Clone.

Gradually, the secret patterns within the metal sword became more and more perfect.

And He Xiangyang was about to begin the final step of forging, which was also the most difficult step.

That was, to fuse some of the Light and Time Origin Laws secret patterns within the metal sword.

Only in this way would the success rate be higher when later engraving the light-time sword's secret patterns.

Otherwise, the possibility of failure would be very high.

He Xiangyang began to carefully apply the Light-Time Fusion Law.

He Xiangyang dared not use force, nor did he dare to mobilize too much energy.

He Xiangyang only used a tiny bit of energy to manipulate the Light-Time Fusion Law.

He Xiangyang proceeded like this, testing little by little, fusing a trace of the Law of the Origin of Light and the Time Origin Law.

During this process, He Xiangyang covered the entire sword with his psychic energy, constantly monitoring the metal sword.

This was to prevent any unnoticed errors from occurring in the metal sword during the process of fusing a trace of the Law of the Origin of Light and the Time Origin Law secret patterns.

Only by constantly monitoring could errors be remedied in time when they appeared.

As He Xiangyang tested repeatedly and found that the balance of the Light and Time Origin Laws had not been broken.

He Xiangyang began to gradually increase the energy output.

And the Light-Time Fusion Law that He Xiangyang was manipulating also began to slowly increase.

With each gentle hammer blow, a portion of the secret patterns of the Light and Time Origin Laws within the metal sword began to entangle.

And as a portion of the secret patterns of the Light and Time Origin Laws began to entangle, the law fluctuations within the metal sword also began to become more intense.

At this moment, He Xiangyang's heart was in his throat.

He Xiangyang was afraid that a single mistake on his part would disrupt the balance of the two Origin Laws.

Soon, under the guidance of He Xiangyang's Light-Time Fusion Law, a portion of the secret patterns of the Law of the Origin of Light and the Time Origin Law had completely entangled.

And a trace of secret patterns had already begun to fuse.

He Xiangyang stared intently at the trace of secret patterns that were beginning to fuse, carefully manipulating the Light-Time Fusion Law to guide them.

Soon, that trace of the Law of the Origin of Light and a trace of the Time Origin Law's secret patterns, in He Xiangyang's joyful gaze, fused together.

And what followed was that the metal sword began to emit a trace of the Light-Time Fusion Law's law fluctuations.

After completing this step, He Xiangyang breathed a sigh of relief and stopped the forging hammer in his hand.

The first two steps of refining—material fusion and forging—He Xiangyang had finally completed.

This also meant that the refining of the heavy treasure was already halfway done.

He Xiangyang did not immediately engrave the secret patterns.

Instead, He Xiangyang stretched his body a bit, then lay down to recover his spirit.

Previously, while contemplating the forging method and during forging, He Xiangyang had continuously covered the metal sword with his psychic energy.

During this process, He Xiangyang's psychic energy was constantly being consumed.

Although he had the Life Ancient Tree Clone providing energy, He Xiangyang still felt mentally exhausted at this moment.

Therefore, He Xiangyang was now preparing to first adjust his mental state.

Then, he would begin engraving the secret patterns in the best possible mental state.

After all, engraving secret patterns was also very mentally taxing.

Moreover, because of the existence of the Light-Time Fusion Law's secret patterns, the secret patterns He Xiangyang had to engrave were still very complex.

After adjusting for a period of time, He Xiangyang finally adjusted his mental state to its optimal condition.

Next, He Xiangyang was going to start contemplating the engraving plan for the secret patterns.

Although He Xiangyang could also engrave directly according to the blueprint.

However, in that case, due to some minor differences, the possibility of failure was still not small.

Therefore, He Xiangyang needed to fine-tune the secret patterns based on the metal sword he had refined.

At this point, He Xiangyang would need to use a very important function in the Duobao Small World.

That was, it could simulate some simple secret patterns and metals within the Duobao Small World.

This way, He Xiangyang could more intuitively perceive the differences in the metal sword he refined and fine-tune the secret patterns accordingly.

This simulation, when refining in reality, could also have a portion of consciousness simulated in the Duobao Small World.

As long as one was a member of the Refiner Alliance, they could simulate for free.

The next moment, a gigantic metal sword appeared before He Xiangyang.

Furthermore, the law secret patterns inherent in the metal sword were also clearly displayed before He Xiangyang.

Then, He Xiangyang drew a secret pattern diagram next to the simulated metal sword.

This secret pattern diagram was the light-time sword's secret patterns that He Xiangyang intended to engrave on the metal sword.

Next, He Xiangyang began to observe the metal sword's secret patterns and the secret patterns that needed to be engraved.

He Xiangyang would observe for a while, then begin to slightly adjust the light-time sword's secret patterns.

In reality, He Xiangyang mainly adjusted the positions where the light-time sword's secret patterns should be engraved, their starting points, and the positions of some secret pattern nodes.

As for the overall structure of the secret patterns, there was actually no change.

He Xiangyang marked all the secret pattern nodes that the light-time sword required for engraving onto the metal sword's secret patterns.

Many of these nodes required the fusion of the Law of the Origin of Light and the Time Origin Law secret patterns.

Therefore, when marking, He Xiangyang needed to ponder each node deeply.

Soon, He Xiangyang had marked the secret pattern nodes on the simulated gigantic metal sword.

The next step was to begin engraving the secret patterns.

He Xiangyang took out the engraving knife he had specially selected, which contained the Light-Time Fusion Law.

He Xiangyang familiarized himself with the engraving knife and the secret patterns on it.

Then, He Xiangyang placed the simulated metal sword beside him, and, referencing the secret pattern nodes on it, began the engraving of the secret patterns.

He Xiangyang was very careful during the engraving.

Although this was simulated refining, it was actually no different from refining in reality.

Therefore, He Xiangyang was very careful at this moment.

If he succeeded in the simulated refining, then he would likely succeed in reality as well.